If you are a good bikers would have understood of what should be done when we want to ride a motorcycles below are a few tips to hold:
1. Check the Oli
Check the engine oil by removing oil deep stick, oil condition must be in the position of Full or at least half, if the position of oil under low line immediately check where is the location of leaking, fix it and immediately add the oil to the full position.
2. Chain and Gear.
Chain condition not to loose or too tight, if out of standard its easy to loose out, as if too tight chain will be broken off, set the chain tension as standard. If the chain could not be fit again following a gearnya replace front and rear gears as a sets. But ... if chain still in good condition you can cut it 2 or 4 piece its very easy.....
3. Air Filter.
Check the air filter please keep it clean, the dirty air can easily to eroded the piston ring as a result the engine oil become burnt at cylinder liner, later engine oil will be less than standard level.
4. Battery.
Check the water regularly not waiting until battery water become dry, except the battery type is M / F or Maintenance Free.
5. Gas Cable
This also needs to be checked and give it oil for lubrication, usually the symptoms of gas cable would break-off ther're some kind of "play" at the gas grip and engine rev. does not go down gently, in other words there are detained ...
Keep Rolling thunder Bro,......
No comments:
Post a Comment